Step 2: Under Router Settings, change the router´s IPĪddress to 192.168.225.1 and click Save SettingsĪfter saving your settings, you will no longer use the IP address- 192.168.0.1 to access the router. Step 1: Click on Setup > Network Settings To fix this, you will need to change the D-Link routers IP address: In some cases, the modem/router provided by your internet provider may have the same IP address as your D-Link Router (192.168.0.1), this will cause the router to not get online. If the above steps have failed, reset your router- How do I reset my router to factory default? If you are not sure, contact your ISP to verify.ģ. Ensure your username and password are entered correctly. Bell Sympatico), The Internet Connection Type should be PPPoE (Username/Password) If you are using a DSL Internet Service (phone line) which requires a username and password (eg. Cogeco, VideoTron, Rogers) the Internet Connection Type should be configured as Dynamic IP (DHCP) If you are using a Cable Internet Service (eg. Click on the Setup Tab and click Manual Internet Connection Setup Check the routers Internet Connection Settings: If still disconnected, process to the next step. If the status changes to Connected, your internet should be working. Wait up to 2 minutes and check the Network Status again. Power Off your Internet Modem (Not the D-Link Router) for 20 seconds and then power it back on.
If Disconnected- please try the steps below: Network Status- When the internet is connected/working, this should be Connected. Do not proceed further until this states Connected. If the cabling is correct, try using a different Ethernet cable. Once you’ve accessed the page there are a variety of. When prompted, enter the settings password shown on the bottom of the Hub. Enter If you have enabled Modem Mode on the Hub you will need to use 192.168.100.1 instead.
Please check your cabling (in step 1 above). Enter 192.168.0.1 into the address bar of your browser, the settings page will then load. Cable Status- This should state Connected - If the status is Disconnected, the router is not detecting your modem. Under the WAN/Internet Section check the following: Step 1: Log into your router- How do I log into my router? - Video Version- Click Here Ensure your Internet modem is connected to the WAN/Internet Port on the back of the D-Link Router. Your router may not be able to get online for a few different reasons.ġ. If(!this.Q:I cannot get my router online, how do I fix this? import React, )įull Code Listing Below (react-router version 2.8.1): requireAuth(nextState, In v4 you just create a route component that checks if uses is authenticated and return the next components and of course next component can be other routes.
0 kommentar(er)
